Jetson Nano PPP installer

Hardware Setup

After preparing the HAT, attach it to 40-pin of the Nvidia Jetson Nano.

Software Setup

  1. Download the PPP installer script using the following command.
wget https://raw.githubusercontent.com/sixfab/Sixfab_PPP_Installer/master/ppp_installer/install_ppp_jetson.sh
  1. Change the permission of the script.
sudo chmod +x install_ppp_jetson.sh
  1. Now install the script using following command.
sudo ./install_ppp_jetson.sh
  1. During the installation, it will as several questions, answer them accordingly.

Question

Answers

Choose your Sixfab Shield/HAT

4: Cellular IoT HAT

What is your carrier APN?

internet (Your APN might be different)

Does your carrier need username and password?

n

What is your device communication PORT?

ttyTHS1

📘

/dev/ttyTHS1 is the serial communication.

  1. Once the installation is complete, press Enter in order to reboot.

  2. After the reboot, turn on the module by pressing the POWER button and wait few seconds until you see the STATUS LED turned on.

  3. Run the following command to run the PPP.

sudo pon

To understand PPP further you may check PPP documentation.

🚧

Please submit your technical issues and feedback to the community forum.

Updated 4 months ago


Jetson Nano PPP installer


Suggested Edits are limited on API Reference Pages

You can only suggest edits to Markdown body content, but not to the API spec.